Nature-Driven Biocompatible Epidermal Electronic Skin for Real-Time Wireless Monitoring of Human Physiological Signals.

Wearable bioelectronic patches are creating a transformative effect in the health care industry for human physiological signal monitoring. However, the use of such patches is restricted due to the unavailability of a proper power source. Ideal biodevices should be thin, soft, robust, energy-efficient, and biocompatible. Here, we report development of a flexible, lightweight, and biocompatible electronic skin-cum-portable power source for wearable bioelectronics by using a processed chicken feather fiber. The device is fabricated with a novel, breathable composite of biowaste chicken feather and organic poly(vinylidene fluoride) (PVDF) polymer, where the chicken feather fiber constitutes the "microbones" of the PVDF, enhancing its piezoelectric phase content, biocompatibility, and crystallinity. Thanks to its outstanding pressure sensitivity, the fabricated electronic skin is used for the monitoring of different human physiological signals such as body motion, finger and joint bending, throat activities, and pulse rate with excellent sensitivity. A wireless system is developed to remotely receive the different physiological signals as captured by the electronic skin. We also explore the capabilities of the device as a power source for other small electronics. The piezoelectric energy harvesting device can harvest a maximum output voltage of ∼28 V and an area power density of 1.4 µW·cm-2 from the human finger imparting. The improved energy harvesting property of the device is related to the induced higher fraction of the electroactive phase in the composite. The easy process ability, natural biocompatibility, superior piezoelectric performance, high pressure sensitivity, and alignment toward wireless transmission of the captured data make the device a promising candidate for wearable bioelectronic patches and power sources.

Enhanced dielectric, ferroelectric, energy storage and mechanical energy harvesting performance of ZnO-PVDF composites induced by MWCNTs as an additive third phase.

The present work highlights an attempt of fabricating a nanocomposite by the addition of multi-walled carbon nanotubes (MWCNTs) as a third phase into flexible ZnO-poly(vinylidene fluoride) (ZnO-PVDF) composites. MWCNTs played a very important role in distributing ZnO fillers in the PVDF matrix more homogeneously and increased the connection capability. Enhancement of the piezoelectric phase, dielectric permittivity, ferroelectric polarization, energy storage density and mechanical energy harvesting performance of ZnO-PVDF composites after the addition of MWCNTs was confirmed from the respective characterization studies. The sensing capability was demonstrated by the generation of ∼22 V ac output voltage through the application of human finger tapping on 15 wt% ZnO and a 0.1 wt% MWCNT-loaded PVDF (15PZNT) based composite film. The rectified voltage from the fabricated 15PZNT film was used to charge a 10-µF capacitor up to ∼3 V which was used for the illumination of 30 commercial LEDs. The maximum power density from the film was found to be 21.41 µW cm-2 at 4 MΩ load resistance. The effect of the addition of MWCNTs was also verified by simulation using COMSOL Multiphysics software.